Garden Gates, Driveway Gates, Wood Fences, Garden Arbors, Porch swings by Prowell Woodworks Garden Gate Products Gate Hardware Contact Prowell Woodworks About Charles Prowell Woodworks Payment Gateway Site Map

prowell woodworks for garden gates
 

 

Open Style Wood Driveway Gates
Grids Openings at Approximately 5"

>>How to Order


 

 

WOOD DRIVEWAY GATES #13
This Driveway Gate Style is Base Price + 18%
> Go to Base Price Table
 


    DRIVEWAY GATE #13-1
    grid openings 5.1" sq.  
An equal number of full grids horizontally within the fixed width at approximately 5 inches square.. To create an equal number of full grids vertically becomes more difficult. Here we were able to increase the width of the bottom rail to 11-1/2", up from the normal 8-1/2". The homeowner preferred this over the aesthetics of a row of partial grids along the bottom.
 
#13-1
 
Custom Wood Driveway gate #13
 
#13-1
 


San Geronimo, CA

Wood Driveway Gates #13 nestled in the rolling hills of west Marin County, California--flanked by a matching gate on the right and a fixed panel on the left. At 14-1/2' overall between the columns, the gates are mounted to an steel frame exposed on the property side and automated with above-grade motors.

Prowell Woodworks provides the gates and panels.
Automation, keypads, and steel frames are provided and installed by the site contractor.
See Product Specifications for more information on the various site options for Driveway Gates.

  Custom Wood Driveway Gate #13 in Marin County, CA
 
#13-1
 
 
San Geronimo, CA

S
howig the exposed steel frame (Option #2 on the Price Table). The steel frame is fabricated to the dimensioned drawings provided by Prowell Woodworks to insure it aligns with the gate rails and stiles.
  Wood Driveway Gate with steel in Marin County, CA
 
#13-1
 
San Geronimo, CA

A
nd finally, in keeping with a tradition that began ages ago, we post a photo of the resident munchkin.
  wood driveway gates #13 in Marin County, CA
   
   
 
#13-3
 
    DRIVEWAY GATE #13-3
      Grid Openings: 4.27"W x 5.09" H


Kentfield, CA

Flush-joined grids at a slight vertical rectangle. Because the gate height is almost exctly the same as the net width of each gate, we were able to add only 1/4" to the width of the bottom rail to accomplish the equal grids.

Many communities require that a certain percentage of the Driveway Gate is open, with a smaller percentage as solid. This is obviously to prevent a neighborhood with barrier-like gates fronting the properties.

  custom wood driveway gates #13 in Kentfield, CA
 
#13-3
 


Kentfield, CA

T
here is a decided difference between grids that overlap, such as lattice, and grids that are joined flush.

Note: The below finish was applied on site and with a product that features a top sealer coat. The result is often not only a splotchy finish, but a sealer coat that may in time peel. The best exterior finish on the market today is WoodRX. An absorbing, non-solvent, finish with a 7-8-year lifeline that will never peel or check and if not maintained, simply fade over the years to a natural graying patina.

Note: we do not recommend any product that is two-part, or has an overlayment seal, or is a solid-body stain or paint. The grades and specifications of the cedar Prowell stocks does not need any finish, whether you are in Duluth or Atlanta.. And yet it is often aesthetically preferable, in which case we must remember the wood will breath, interminably, and the finish must therefore remain flexible.

See Pre-Finish Options

  Wood Driveway Gates with open grids
 
#13-3
 

Kentfield, CA

A
s an Automatic Gate, showing the sub-Grade SEA motors. Mounted to pins that pivot, with the top and bottom pins perfectly aligned. The motor is under the steel plate on the bottom. More information on this type of automation motor can be found on the Specifications page. If you or your installer opt for the in-ground motor, Prowell will call out the clearance and provide the plates top and bottom mortised into the gate.
  Wood Driveway Gate #13 automated   wood driveway gates automated
 
#13-3
 


Kentfield, CA

T
he matching Pedestrian Gate style #60-1

An equal number of square grids horizontally is easily calculated within a fixed width. Vertically, however, and we are almost always left with the choice of either a partial grid at the bottom, or an oversized grid height, or a bottom rail with an increased width. Here our bottom row of grids are the same size as the others by increasing the width of the bottom rail. But beware, in that this is not always possible and depends largely on the size of the remainder grid.

  custom wood garden gate #60 in Marin county, CA


>>>To GALLERY 2
driveway gates
The Designs of Prowell Woodworks are protected by Patents and Patents Pending.


1. 8 0 0 . 4 6 6 . 1 8 5 0 (PST)

 

 

 





SHIPPING TO ALL 50 STATES
©1996-Present Charles and Ben Prowell.
This Web Site was launched in the Spring of 1996.


1 . 7 0 7 . 8 6 1 . 3 4 0 9 (FAX)



 

 

 

Privacy  

Unless otherwise noted, products appearing on this site are the sole design rights of Charles & Ben Prowell.

#13--0761-Grimshaw
#13-1 (1108-Tsao