ARBOR TRELLIS 19

San Francisco, CA
Ground posts not included

Garden Trellis 19 from above, which can be seen only from the rooftop neighbors.

Palo Alto, CA

Four-Post Wood Pergola with overhead inset panel and a front and rear Valance Panel. The Garden Pergolas ship as complete assemblies to be seated on top of existing site posts, masonry columns, or as an extension to site posts, shown below. The entire assembly, weighing 175 lbs, is set onto the site posts..
*The site posts below have been wrapped, for an outside dimension of 8″ x 8″.

Corner view.
Typical Prowell 4×4 Cap
To Prowell Post Caps

The overhead insert panel.

Highland, New York

The homeowner has relocated a series of existing picket fences to become a part of the overall assembly until, we’re told, they eventually commission us to provide the proper flanking and foyer panels.

And what are potted palms doing in New York?

Highland, New York

Each of the varying methods of joinery used in arbor trellis 19 are utilized for a purpose. All driven by design to allow the assembly to breath, to expand and contract. When these parameters are met, in conjunction with stress loads called upon each segment, we have a construction that will by all accounts last far into the future.

Highland, New York

A subsequent photo sent in during the record-setting winter of 2013-14.

Greenbrea, CA

The original Four-Post Wood Arbor Trellis 19 with Drop-In Ceiling Panel and one Valance Panel.

When within the Freight limitations, Arbor #19 ships as a complete assembly to be seated on top of the site posts or beams. The below assembly weighs approximately 125 lbs.

While the Smiths sleep, dreaming of sliver-lined clouds, an epic battle rages. Waged across continents, the eternal good vs evil in a proprietary struggle for balance within the cosmos of a teetering inequality.

IN-PROGRESS

Charles applying the top caps.

Cutting the arbor’s primary joints by hand.

Charles clamping up the leg extensions and valance panels.

Ben fitting the mortises and clamping the overhead assembly.

With both the lower post extensions and the upper short extensions in place, Ben planes the overhead insert to a perfect fit.

Charles dry-fitting the dual tenons for the lower post extensions.

This is the Prowell Post Cap.